Guides, Manuals, Parts & Support

1) Remove all the contents from inside of the vacuum cleaner container.

2) Turn the container upside down and insert the feet with casters into the slots and apply pressure until they click into place.

3) Insert the wheel axle into the rear wheel housing on the base. Insert a washer onto the axle followed by the rear wheel and another washer. Insert the wheel retaining pin into the hole on the end of the axle to lock into place. Push fit the hub cap onto the wheel. Repeat the same steps on the other end of the axle).

4) Attach the carry handle into the slots located on the top of the power head. Secure them with supplied screws.

5) To position the hose storage rack, insert one end into the channel on the side of the power head, making sure it is secured in place. Apply inward pressure to the other side and insert it into the opposite channel.

6) Your vacuum cleaner comes ready for dry vacuum cleaning with the cartridge filter pre-installed. If the cartridge filter is not installed.

7) Optionally, for improved dust filtration and hygienic disposal, fully fit the dust bag flange onto the inlet stub. NOTE: The dust bag is for dry pick-up only.

8) For wet vacuuming and carpet shampoo cleaning, replace the cartridge filter with the foam filter supplied. Do not use a dust bag when wet vacuuming or carpet shampoo cleaning. If the foam filter is not installed.

9) Secure the power head back on the container using the 2 side latches.

10) Insert the detergent connecting hose into the detergent tank inlet coupling.

11) Insert the locking end of the hose into the suction port of the container and turn clockwise to lock into place. Connect the detergent delivery tube onto the detergent outlet coupling located in the front of the power head.

12) Insert the supplied battery into the suction hose handle ensuring the terminals are correctly inserted in the direction as shown.

13) Insert the battery cover into position. Angle the cover into the slot on the battery compartment and press down the battery cover to click into place.

14) Choose the desired accessories and/or the extension wand and push fit onto the remote control handle.

1) Remove the suction hose from the vacuum. Press down the latch on the detergent outlet coupling and unplug the delivery tube connector from the vacuum.

2) Keep all safety devices, air vents and the motor housing free of dirt and dust. Use a soft, dry brush to clean the equipment regularly.

3) Clear all dirt or debris from the collection tank after each use. Allow to dry before replacing the power head. Do not use cleaning agents or solvents; these may damage the appliance.

4) Check the hose, attachments, and power cord to verify that they have not been damaged, or any debris is trapped and blocking airflow.

Cleaning Cartridge Filter

1) Remove the filter and clean by gently tapping or brushing dirt off. For optimal performance it is recommended to replace the old filter with a new filter regularly.

2) If necessary, use a mild soap and water solution to wash cartridge filter and rinse with clean water. Allow the filter to air dry before re-installing.

Cleaning Foam Filter

Remove the foam filter and use a mild soap and water solution to wash and rinse with clean water. Allow the filter to air dry before installing and using again.

Cleaning & Replacing Exhaust Filter

1) Unlock the exhaust filter cover by lifting the locking tab upwards to the release. Pull the cover out.

2) Remove the exhaust filter from the vacuum and clean by gently tapping or brushing off dirt. For optimal performance it is recommended to replace the old filter with a new filter regularly.

3) Install the cleaned or new filter. Then insert the filter cover tabs into the upper slots and lock the filter cover into place.

Changing the Battery in Remote Control Handle.

NOTE: Only replace the battery with a 27A 12V Alkaline battery.

1) Pry off the battery cover and remove it from the battery compartment (Fig. 37).

2) Remove the battery from the battery compartment. Insert the new battery with the terminals in the direction as shown.

3) Install the battery cover back into place.