Guides, Manuals, Parts & Support

1) Remove all the contents from inside of the vacuum cleaner container
2) Attach the carry handle into the slots located on the top of the power head.
3) Turn the container upside down and insert the feet with casters into the slots and apply pressure until they click into place. Secure them with supplied screws.
4) Your vacuum cleaner comes ready for dry vacuum cleaning with the cartridge filter pre-installed.
5) Optionally, for improved dust filtration, fully fit the dust bag flange onto the inlet stub.
6) For wet vacuuming, replace the cartridge filter with the foam filter supplied. Do not use a dust bag when wet vacuuming.
7) Secure the power head back on the container, using the 2 side latches. Make sure the power head is properly installed with the blowing port positioned in the back of the unit.
8) Insert the locking end of the hose into the suction port of the container.
8) Choose the desired accessories and/or extension wands and push fit onto the hose nozzle.

For Detachable Blowing Operation:
This wet/dry vacuum converts to a detachable blower that can be used for leaf blowing in gardens, on decks, and patios.
1) Hold the blower handle and press the blower release button to lift the detachable blower from the blower housing.
2) Secure the locking end of the blower adapter onto the blower port.
3) Fit the blower tube onto the adapter. Make sure the blower tube is secured into place.

4) Firmly hold the blower before turning it on. Turn the appliance on by turning the switch to the ‘I’ ON position.

NOTE: Make sure that the detachable blower is replaced properly onto the blower housing when finished blowing.

1) Keep all safety devices, air vents and the motor housing free of dirt and dust. Use a soft, dry brush to clean the equipment regularly.

2) Clear all dirt or debris from the collection tank after each use. Allow to dry before replacing the power head. Do not use cleaning agents or solvents; these may damage the appliance.

3) Check the hose, attachments, and power cord to verify that they have not been damaged or any debris is trapped and blocking airflow.

Cleaning the Cartridge Filter

Remove the filter and clean by gently tapping or brushing off dirt. For optimal performance it is recommended to replace the old filter with a new filter regularly.

Cleaning the Foam Filter

Remove the foam filter and use a mild soap and water solution to wash and rinse with clean water. Allow filter to air dry before installing and using again.